|The chassis has most holes cut in
it ready for you to use.
Because we do not know which type of
variable capacitors you are using, the main hole will be cut, so one type
of variable can be fitted directly. If you use the type of variable that
has two small mounting screws we have made the laser etch-mark the position
of the two holes ready for you to drill. CHECK these markings are far enough
apart to fit your intended capacitor before you drill these holes!
The laser will cut a hole for the key
knob, but not any mounting holes for your intended key. You must mark and
drill these if they are needed. The hole for the key knob also fits the standard
1/4" jack socket if you want to put one of these in for plugging in an external
You must mark and drill a hole to mount
your chosen receiver coil and also the hole to mount your pa coil
If you make a mistake and drill a hole
incorrectly, don't worry, counter sink the hole and then using a hot soldering
iron solder over and into the countersink. Once excess solder is sanded down
you won't see where the hole was!!
IMPORTANT. When you come to bend the
chassis make sure you bend it the right way up. The laser will etch-mark
where the bend should be but it is up to you to make sure you don't bend
the chassis inside out! Look at the photos and make sure you will bend it